|
||
 |
 |
 |
 |
 |
IMPELLER SELECTION CHART
|
||||||||
| H.P. | 9.5 | 9.25 | AA | A | B | C | ||
| 150 | 2900 | 3050 | 3200 | 3600 | 3800 | 4050 | ||
| 200 | 3200 | 3350 | 3500 | 4000 | 4200 | 4450 | ||
| 250 | 3450 | 3600 | 3700 | 4300 | 4500 | 4800 | ||
| 300 | 3800 | 3950 | 4050 | 4550 | 4800 | 5100 | ||
| 350 | 4050 | 4200 | 4300 | 4750 | 5100 | 5350 | ||
| 400 | 4250 | 4400 | 4500 | 5050 | 5300 | 5600 | ||
| 450 | 4450 | 4600 | 4700 | 5250 | 5500 | 5850 | ||
| 500 | 4650 | 4800 | 4950 | 5400 | 5700 | 6050 | ||
| 550 | 4800 | 4950 | 5100 | 5550 | 5850 | N/A | ||
| *THESE RPM VALUES MAY VARY ACCORDING TO HOW YOUR BOAT ALLOWS THE PUMP TO LOAD | ||||||||
HORSE POWER REQUIREMENTS ARE AT THE PUMP SHAFT |
||||||||
NOTE: A Good Rule of Thumb when changing over to a Precision Billet or Aggressor Impeller is to drop one full cut in order to keep your RPM's the same. This is due to the Impellers aggressive load and flow volumes.
| AMERICAN TURBINE JET PUMP IMPELLER SPECIFICATIONS | |||
| IMPELLER SIZE | LARGE DIAMETER | SMALL DIAMETER | MACHINED ANGLE |
| 9 1/2" | 9-1/2" | 8-1/4" | 25 DEGREES |
| 9 1/4" | 9-1/4" | 8-1/4" | 20 DEGREES |
| AA | 9-3/32" | 7-13/16" | 25 DEGREES |
| A | 9" | 7-1/4" | 30 DEGREES |
| B | 8-3/4" | 6-3/4" | 33-1/2 DEGREES |
| C | 8-1/2" | 6-1/2" | 33-1/2 DEGREES |
| home page | | | about us | | | services | | | ARS parts | | | shop online | | | on sale | | | contact us | | | links | | | gallery |